Installation matters of thrust self-aligning roller bearing

thrust self-aligning roller bearing 

1. When installing the bearing, the bearing oil seal shall be cleaned and then coated with clean high-quality lubricating oil.

2. When installing the bearing, the stress shall be uniform without hammering. If the fit interference is large, put the bearing into mineral oil and heat it to 90 ° - 100 °, and then install it immediately.

3. The warehouse for storing bearings shall be clean and the relative humidity shall not exceed 65%.

4. The bearings in stock shall be cleaned and oiled every other year, and the oil seal packaging shall be kept in good condition.

5. When using the bearing, there should be a good sealing and dust-proof device, and the working condition should be checked frequently.