1. When the one-way bearing is removed for inspection, the appearance record should be made by taking pictures and other methods.

2. In addition, it is necessary to confess the amount of remaining lubricant and sample the lubricant before cleaning the bearing.

3. The cleaning of bearings is carried out by rough washing and fine washing, and metal mesh can be put on the bottom of the container.

1), coarse washing, in the top of the oil with a brush to eradicate grease or adhesive. At this time, if the bearing is changed in the oil, attention will be paid to the rolling surface due to foreign bodies and other hazards.

2) During fine washing, the bearing should be gradually transformed in the oil and carefully carried out.

4. The commonly used cleaning agent is neutral water free diesel or fuel oil, and sometimes warm lye is used according to the need. No matter what kind of cleaning agent is used, always filter to maintain cleaning.

5. Immediately after cleaning, apply anti-rust oil or anti-rust grease on Nevada one-way bearing.

As for the one-way bearing, it is very important to identify or guess whether the bearing has defects in the work without disassembly inspection, which is very important to the forward productivity and economy. The primary identification methods are as follows:

1) Identify by movement

It takes a lot of experience to recognize movement. It is necessary to identify unidirectional bearing movement and non-bearing movement through sufficient drill. For this reason, the work should be carried out by special personnel as far as possible. The bearings can be clearly heard by using the audiophore or audiophore stick attached to the housing.

2) Identify by working temperature

The method is a comparative identification method, which is only used in the working situation does not change too much. To this end, it is necessary to keep a continuous record of temperature. When defects occur, not only the temperature increases, but also irregular changes will occur.

3) Identification by lubricants

The lubricant sampling analysis, by its turbidity is mixed with foreign matter or metal powder to distinguish. This method is particularly useful for one-way bearings or large one-way bearings that cannot be approached to query.