Installation of angular contact ball bearing
Angular contact ball bearing
1. When installing the bearing, the stress shall be uniform and direct hammering is not allowed. For example, if the fit interference is large, the bearing shall be heated in an air heating furnace or oil furnace with automatic temperature control, and the heating temperature shall be strictly controlled below 100 °.
2. The bearing equipped with nylon cage can work continuously and stably for a long time at - 40 ° - 120 °, the working time at 150 ° shall not exceed 4 hours, and the transient temperature peak can reach 180 °.
3. The warehouse for storing bearings shall be clean and dry, and shall not be stored in the same warehouse as chemical products. The relative humidity shall not exceed 65%, and the bearings shall not be stored on the ground.
3、 Installation matters of self-aligning roller bearing